Eltek WBK9 Water Block Safety Flow Kit #9, 3/8 Inch Compression x 1/4 Inch Quick Connect, 36 Inch Braided Line with Reset Device

  • Model: HHD WBK9
  • Manufactured by: HHD

$89.79

Add to Cart:
The Eltek WBK9 Water Block Safety Flow Kit #9 is a mechanical water overflow protection system designed to help reduce the risk of water damage caused by excessive continuous water flow in commercial coffee brewers, beverage dispensers, water filtration systems, and other water-fed equipment. Manufactured by ELTEK Group, the Water Block measures the volume of water passing through the valve and automatically shuts off the water supply when the preset continuous flow limit is exceeded.

The WBK9 features a 3/8 Inch compression inlet, 1/4 Inch quick-connect outlet, 36 Inch stainless steel braided water supply line, and a separate Water Block Reset Device. This configuration provides flexible water connections and convenient access to the reset mechanism following a safety shutoff. The Water Block operates mechanically without electricity or batteries and allows the maximum continuous water volume to be adjusted between 1.3 and 13.2 gallons.

Features

Mechanical water overflow protection system
Automatically shuts off water when the preset continuous flow volume is exceeded
Adjustable shutoff volume from 1.3 to 13.2 gallons
Requires no electricity, batteries, or electronic controls
Automatically resets measured water volume during normal flow cycles
Manual reset required after safety shutoff activation
Includes separate WBRD Water Block Reset Device
3/8 Inch compression inlet connection
1/4 Inch quick-connect outlet connection
Includes 36 Inch stainless steel braided water supply line
Includes Water Block valve with key and instructions
Includes installation adapters and 2 Inch filter clip
Designed for vertical installation only

Specifications

Manufacturer: ELTEK Group
Part Number: WBK9
Product Type: Water Block Safety Flow Kit #9
Operation: Mechanical Water Flow Monitoring
Adjustable Continuous Flow Volume: 1.3 to 13.2 Gallons
Burst Pressure: 725 PSI
Maximum Static Pressure: 145 PSI
Minimum Flow Rate: 0.5 GPM
Maximum Water Temperature: 158 F
Water Block Inlet: 3/4 Inch Male Garden Hose Thread
Water Block Outlet: 3/4 Inch Female Garden Hose Thread
Kit Inlet Connection: 3/8 Inch Compression
Kit Outlet Connection: 1/4 Inch Quick Connect
Braided Water Line Length: 36 Inch (3 Feet)
Braided Water Line Connections: 3/8 Inch Compression x 3/8 Inch Compression
Separate Reset Device: Included (WBRD)
Rated Service Life: Approximately 80,000 Gallons
Power Requirements: None
Installation Orientation: Vertical Only

Kit Includes

(1) WB - Water Block Safety Valve with Key and Instructions
(1) WBRD - Water Block Reset Device
(1) MGH6C - Male Garden Hose Adapter with 3/8 Inch Compression
(1) LGH4 - Liquifit 1/4 Inch Quick Connect x 3/4 Inch Garden Hose Fitting
(1) SCC36-66 - 36 Inch Stainless Steel Braided Water Line, 3/8 Inch Compression x 3/8 Inch Compression
(1) OC - 2 Inch Filter Clip

Common Applications

Commercial coffee brewing equipment
Automatic-fill coffee brewers
Commercial beverage dispensing systems
Water filtration systems with compatible connections
Office coffee service equipment
Restaurant and convenience store beverage stations
Water-fed equipment requiring continuous flow protection
Commercial beverage equipment installations

Installation Information

The Eltek Water Block must be installed in a vertical position for proper operation. The adjustable shutoff volume should be selected according to the normal water consumption of the connected equipment. If the volume of water passing through the valve continuously exceeds the selected limit, the Water Block shuts off the water supply and remains closed until manually reset according to the manufacturer's instructions.

During normal operation, when water flow stops before reaching the selected limit, the Water Block mechanically resets its measured volume and is ready for the next flow cycle. No electrical connection or battery is required.

The WBK9 includes a separate WBRD Water Block Reset Device for resetting the valve following a safety shutoff. Its 36 Inch stainless steel braided supply line provides additional installation flexibility where rigid water connections may be inconvenient. The supplied MGH6C and LGH4 fittings adapt the Water Block to the specified 3/8 Inch compression inlet and 1/4 Inch quick-connect outlet.

The Water Block responds to excessive continuous water flow rather than detecting moisture or standing water. It does not replace a conventional leak detection system and may not stop small leaks or intermittent water loss that remains below the selected shutoff volume.

Related Products

Eltek WBK8 - Water Block Safety Flow Kit with 36 Inch Braided Line and Manual Shutoff Valve
HHD WBRD - Water Block Reset Device
HHD FBP - Flood Buzz Water Leak Alarm
HHD LSV - Automatic Water Leak Stop Valve

The Eltek WBK9 Water Block Safety Flow Kit provides an additional layer of protection for commercial beverage equipment connected to a pressurized water supply. A leaking fitting, failed inlet valve, or other water system malfunction can allow water to flow continuously, potentially causing equipment damage and costly cleanup. By limiting the maximum continuous volume delivered to the equipment, the Water Block helps reduce the amount of water released during certain plumbing or equipment failures.

For restaurants, offices, convenience stores, and commercial coffee service installations, the WBK9 combines mechanical water overflow protection with a flexible stainless steel supply line and separate reset device. These components make it a practical choice for installations where both water flow protection and convenient servicing are important.

Compared with the WBK8, which includes a manual ball shutoff valve, the WBK9 includes the separate WBRD Water Block Reset Device. Both configurations provide a 36 Inch braided supply line, but their included accessories differ.

Verify the 3/8 Inch compression inlet, 1/4 Inch quick-connect outlet, operating pressure, water flow requirements, and available installation space before ordering. The Water Block must be installed vertically and adjusted to accommodate the normal water consumption of the connected equipment.
  1. Home
  2. Accessories
  3. Eltek WBK9 Water Block Safety Flow Kit #9, 3/8 Inch Compression x 1/4 Inch Quick Connect, 36 Inch Braided Line with Reset Device
Copyright © 2026 Discount Coffee Equipment. Powered by Zen Cart